In case of difficulty
What seems to be a serious trouble may some-
times be due to a simple mistake. Before calling for
service, check the items shown in the following
table again. (If you request servicing due to the
reasons shown in the table, the service may be
charged in some cases.)
Pressing a key cannot initiate an operation or
turn the unit on.
¶
The HOLD switch of the main unit or remote
control is set to ON.
]Set the switch to off.
¶
The batteries are exhausted.
]Replace the 2 or 4 alkaline batteries, or
recharge the rechargeable batteries.
¶
The disc is placed upside down.
]Place the disc with the labeled side up.
¶
Condensation has occurred inside the unit.
]Leave the unit for about 1 hour before re-use.
¶
The AC adaptor is disconnected.
]Connect it properly.
No sound is heard from the headphones.
¶
The headphones are connected incompletely.
]Insert the plug securely into the
PHONE
jack.
¶
The headphones are connected to LINE OUT
jack
]Insert the plug securely into the
PHONE
jack.
¶
The volume is set to the minimum position on
the unit.
]Adjust the volume on the unit.
Sound skips, or is interrupted.
¶
A strong vibration that exceeds the capacity of
the ASP has occurred.
]Place the unit in a place not subject to
vibration.
¶
The disc is dirty.
]Clean it.
¶
The headphone plug is dirty.
]Clean it.
Noise interferes
¶
The headphone plug is dirty.
]Clean it.
¶
The batteries are low.
]Replace or recharge the batteries.
¶
The headphones are connected incompletely.
]Insert the plug securely into the
PHONE
jack.
¶
A source of strong magnetism or radio wave,
such as a TV set or cellular phone, is present
near the unit.
]Install the unit away from a TV set, cellular
phone, etc.
Rechargeable batteries cannot be recharged.
¶
Commercially available rechargeable batter-
ies are used.
]Use the exclusive rechargeable batteries
(NB-3A70).
Note:
1. This system uses a microcomputer so it may
malfunction due to external noise or interference.
In such a case, unplug the power cord and re-
move the batteries, then re-connect the power
cord and insert the batteries again.
2. Erroneous operation may occur when the head-
phone plug is plugged or unplugged; but this is
not a malfunction.