Remote Controller; Battery Installation; Remote Controller Mode Switch - Kenwood DNX7220 Instruction Manual

Remote Controller

This unit can be operated using the Remote Controller supplied with the unit.
¤
• Put the Remote Controller in a place where it will not move during braking or other operations. A dangerous situation could
result, if the Remote Controller falls down and gets wedged under the pedals while driving.
• Do not place the battery near an open flame or heat source. This may cause the battery to explode.
• Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause the battery to leak
fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately rinse with water and consult a physician.
• Place the battery out of reach of children. In the unlikely event that a child swallows the battery, immediately consult a
physician.

Battery installation

Use two "AAA"/"R03"-size batteries.
Insert the batteries with the + and – poles aligned
properly, following the illustration inside the case.
⁄
• If the Remote Controller operates only over shorter
distances or does not operate at all, it is possible that
the batteries are depleted. In such instances, replace the
both batteries with new ones.
86 DNX7220

Remote Controller mode switch

The functions operated from the remote
controller differ depending on the position of the
mode switch.
AUD mode
Switch to this mode when
controlling a selected source or
tuner source, etc.
POSITION
DVD mode
Switch to this mode when playing
AUD
DVDs or CDs etc. with the player
•
DVD
integrated in this unit.
•
•
TV mode
T V
•
This is switched when controlling
NAVI
TV.
RETURN
NAVI mode
This is switched when controlling
CANCEL
Navigation unit.
⁄
• The position of the remote control mode switch is
indicated in the title of each mode, e.g., "(AUD mode)".
• When controlling a player that is not integrated in the
unit, select "AUD" mode.