Searching A Track By Listening To Track Passages - Zappintm; Radio; Storing And Receiving Stations; Storing Automatically - Btm - Sony CDX-GT640UI Operating Instructions Manual
Fm/am compact disc player
Hide thumbs
Also See for CDX-GT640UI:
- Operating instructions manual (140 pages) ,
- Specifications (2 pages) ,
- Installation/connections (2 pages)
Table of Contents
Advertisement
Searching a track by listening to
track passages -
ZAPPINTM
While playing back short track passages in a CD
or USB device in sequence, you can search for a
track you want to listen to.
ZAPPIN mode is suitable for searching for a
track in shuffle or shuffle repeat mode.
ZAP
Select button
~
(BACK)
1
Press
(ZAP)
during playback.
After "ZAPPIN" appears in the display,
playback starts from a passage of the next
track.
The passage is played for the set time, then a
click sounds and the next passage starts.
2
Press the select button or
(ZAP)
when
a track you want to listen is played
back.
The track that you select returns to normal
play mode from the beginning.
To search a track by ZAPPIN mode again,
repeat steps I and 2.
Tips
• You can select the playback time from about 6
seconds/9 seconds/3D seconds (page 19). You
cannot select the passage of the track to playback.
• Press
(SEEK)
+/- or
CD/CD
(ALBUM -/+) in
ZAPPIN mode to skip
a
track or album.
• Pressing
~
(BACK) also confirms
a
track to
playback.
e----i------'
The part of each track to
playback in ZAPPIN mode.
t
~
.....
'
U
Track
-
Radio
Storing and receiving stations
Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Tuning automatically
1
Select the band, then press
(SEEK)
+/-
to search for the station.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
Receiving the stored stations
1
Select the band, then press a number
button
(CD
to
®).
Storing manually
1
While receiving the station that you
want to store, press and hold a
number button
(CD
to ®) until
"MEM" appears.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.
Storing automatically -
BTM
1
Press
(SOURCE)
repeatedly until
"TUNER" appears.
To change the band, press
(MODE)
repeatedly. You can select from FM I, FM2,
FM3, AMI or AM2.
2
Press and hold the select button.
The setup display appears.
3
Press the select button repeatedly
until "BTM" appears.
4
Press
(SEEK)
+.
The unit stores stations in order of frequency
on the number buttons.
A beep sounds when the setting is stored.
Tip
If you know the frequency of the station you want to
listen to, press and hold (
SEEK)
+/- to locate the
approximate frequency, then press
(SEEK)
+/-
repeatedly to fine adjust to the desired frequency
(manual tuning).
Page 12
Advertisement
Table of Contents
