Rear Panel - Rodgers MR-200 Owner's Manual

Song Player/Recorder

Rear panel

A MIDI OUT B, OUT A & IN sockets
Connect the MIDI OUT sockets to the
MIDI IN sockets of two external instru-
ments. The factory settings for these sockets
are: MIDI OUT A should be connected to
the MIDI IN socket of your Rodgers organ.
MIDI OUT B should be connected to an
external sound module (like the MX-200,
for example).
The MIDI IN socket needs to be connected
to the MIDI OUT port of the instrument
your are playing while recording (usually
your organ, digital piano, or synthesizer).
B FOOTSWITCH socket
By connecting an optional Roland DP-2,
DP-6, or BOSS FS-5U footswitch to this
socket, you can start/stop playback or
recording by foot.
C METRONOME [LEVEL] knob and [PHONES]
socket
The PHONES socket allows you to connect
headphones, which might be useful while
recording. You could also connect this
socket to an audio input of an external
14
A B C
D
amplifier or your Rodgers organ using a
standard 1/4" phone audio cable ("guitar
cable"). Before doing so, be sure to read the
note in the gray box on page 6.
There is no absolute need to use this socket as the
metronome beep is also reproduced by the MR-200
itself.
The [LEVEL] knob allows you to set the met-
ronome's level.
D REMOTE EXTERNAL DC OUT socket
Use the supplied cable to connect this socket
to the DC IN in socket of another Rodgers
or Roland sound module (if it is powered by
an adapter). You can connect any instru-
ment that requires 600mA or less.
Carefully check whether the external module can
indeed be connected to this socket. See its owner's
manual or ask your dealer for details.
E DC IN 9V 2A socket
This is where you need to connect the sup-
plied PSB-1U adapter.
E