Tone Setup; Zone Control - Kenwood DDX7019 Instruction Manual

Audio Control

Tone Setup

You can set a Tone curve.
1 Display the Tone screen
See <Equalizer Control> (page 83).
2 Set the Tone
1 6
2 7
3 8
4
1 Bass adjustment items are displayed.
2 Middle adjustment items are displayed.
3 Treble adjustment items are displayed.
4 Bass DC Extend settings (Only when Bass is
selected)
If turned "On", it extends the bass
center frequency to the low register by
approximately 20%.
5 Tone curve becomes flat.
6 Sets the Center frequency.
7 Sets the level.
8 Sets the Q factor. (Only Bass and Middle can
be set)
9 Returns to the original screen.
84 DDX7019/DDX7039

Zone Control

You can set the front and rear audio source.
1 Display Zone Control
Touch [Zone Control] in the Audio Control
Menu (page 82).
5
9
2 Set the Zone Control
1 Turns the Zone Function (that sets different
2 Switches the front and rear audio sources.
3 Sets the front and rear audio source
1
2
3
3
4
source sounds for front and rear speakers)
On or Off.
(This button appears when the Zone
function is On.)
Use "Reverse" to change over the front and
rear audio sources.
separately.
(This button appears when the Zone
function is On.)
5