Kenwood KDC-X879 Instruction Manual page 27

[2] "PLII"
"MUSIC" (Music)
"MOVIE" (Movie)
"MATRIX" (Matrix)
[3] "WOW"
"LOW" (Low)
"MIDDLE" (Middle)
"HIGH" (High)
"USER" (User)
2nd section
Multi-function key operation
[2] "POSI"
[3] "BL/F" [3] "BL"
[3] "F"
[4] "VOFF"
[5] "SW"* [5] "SW LEVEL"
[5] "PHASE"
• Volume offset: Each source's volume can be set as a
difference from the basic volume.
*
• You can control this item when 'Subwoofer Output'
(page 23) is set to "SUB WOOFER ON". Note that you
can control it only when "SP-LEV" is set to any item
other than "None" by 'Audio Setup (Easy mode)'
(page28).
6
Adjust the Audio Control item
Press the [4] or [¢] button.
Each time the button is pressed the setting
switches as shown below.
1st section
Audio Control Item
Dolby ProLogic II setting
SRS WOW setting
OFF setting
Panorama setting
Dimension control
Center width control
FOCUS setting
SRS TruBass Front setting
SRS TruBass Rear setting
SRS 3D setting
[5] "FINE"
[2] "PNRM"
[3] "DIM"
[4] "CT-WDTH"
[5] "FINE"
[2] "FOCUS"
[3] "TruBass-F"
[3] "TruBass-R"
[4] "SRS 3D"
Audio control item
Position setting
Balance setting
Fader setting
Volume offset
Subwoofer level
Subwoofer Phase setting
Range
MUSIC/ MOVIE/ MATRIX
LOW/ MIDDLE/ HIGH/ USER
Through/ Bypass
ON/ OFF
R3 — R1/ Neutral/ F1 — F3
0 — 7
OFF/ 1 — 9
OFF/ 1 — 4
OFF/ 1 — 4
2nd section
Audio Control Item
Position setting
Balance setting
Fader setting
Volume offset
Subwoofer level
Subwoofer Phase setting
• The Adjustment item can also be controlled by the
rotary volume knob. Refer to 'Rotary Volume knob
operation mode select' (page 14).
• When the 'Dual Zone System' (page 25) is ON, each of
the following setup is ignored.
- "WOW"/ "PLII"/ "POSI"/ "PHASE"
• WOW: TruBass, FOCUS and SRS 3D are all set to values
shown below.
WOW FOCUS TruBass SRS 3D
HIGH 8 4
MIDDLE 6 3
LOW 3 2
• FOCUS: Adjusts the sound image by changing the
vertical position of the speakers virtually and
increases or decreases the soundscape.
• TruBass: Assisting the playback for the super bass
sound.
• SRS 3D: Making a natural 3D sound field.
• SRS 3D cannot be set in tuner source.
• The Dimension Control can be set only when the rear
speaker is ON.
• The Center Width Control can be set only when the
center speaker is ON.
• Before you set the "TruBass-F"/ "TruBass-R" to get
the best sound, set the speaker size using the 'Audio
Setup (Easy mode)' (page 28) function. Refer to 'Notes
on Sound Management System' (page 12).
7
Exit Audio Control mode
Press the [6] ("RTN") button.
Range
ALL/ Front-L/ Front-R/ Front
L15 — R15
R15 — F15
-8 — 0
-10 — +10
Normal/ Reverse
4
2
1
27
|
English