Download  Print this page

Handset Setup - Siemens Gigaset 4000 Quick Start Manual

2.4ghz digital technology
Hide thumbs
   

Advertisement

Gigaset 4000 Handset
The handset included with the system is automatically registered with the base
station. Up to a total of four handsets (dependent on system) may be added to any
Gigaset 4010, 4015, 4210, or 4215 base.

Handset Setup

Before using your handset, follow these steps:
1
Remove protective
plastic film from display.
2
Insert batteries
as shown.
IMPORTANT: Charge batteries 12 to 14 hours before using the
handset for the first time. WARNING: Use only NiCd or NiMh
“AA” rechargeable batteries. DO NOT USE ALKALINE, LITHIUM,
OR NON-RECHARGEABLE BATTERIES.
Automatic Registration to Base Unit
1
For automatic registration to base, press and hold the END key to
turn handset off and place in base station with display facing out.
2
After approximately one minute, handset
will register to the base and the next
unassigned intercom number (2 through 4)
is automatically assigned. The intercom
number appears in the upper left of the
handset display. The handset reverts to the
idle state.
3
Place handset in charger or base unit with
display facing out and follow charging
instructions as above.
See User Manual for additional options.
Or visit our Website: www.icm.siemens.com
Visite nuestro sitio Web para obtener instrucciones en español.
3
Place cover on back
of handset and push
gently upward
until it clicks
into place.
Customer Care: 1-888-777-0211
4
Place handset in
charger with
display facing out.
End key and On/Off key
Intercom telephone
number of the handset

Advertisement

Table of Contents
loading