Using Your Hot Cup - Breville Hot Cup vkj142 Instructions For Use Manual

using your hot cup

Before using your Hot Cup for the first time
• Remove your Hot Cup carefully from the box. Remove any packaging and
promotional material and position your Hot Cup on a dry, level, secure work surface
away from the edge.
• Follow the instructions below on using your Hot Cup and discard the first five
measures of boiling water (i.e. the first full tank of water). This will remove any
residues that may remain from the manufacturing process.
Using your Hot Cup
Always position your Hot Cup in such a way that the on/off switch cannot be
accidentally operated especially by children.
1. Press the lid release button.
2. Fill the water reservoir from your cold tap. The water level should be between the
MIN and MAX markings.
3. Close the lid and position your Hot Cup on the power base. Make sure the on/off
switch is in the off position, then plug your Hot Cup in to a mains supply socket. Place
a suitable cup or container with a tea bag, coffee, sugar, etc. below the dispensing
nozzle. Never operate your Hot Cup without a cup or suitable container placed below
the dispensing nozzle.
4. Press the on/off switch down to its on position. The switch will light up blue.
5. A few seconds before the water has finished dispensing, the on/off switch will
automatically switch to its off position.
6. Boiling water will be dispensed into the cup. Your Hot Cup is now ready to use again.
If, after just having boiled, the on/off switch doesn't stay in the on position, wait a few
seconds before trying it again.
Always keep your Hot Cup topped up with water (between the MIN and MAX markings).
That way you'll ensure that it's always ready to use and don't forget, unlike an ordinary
kettle, this will have no effect on the energy your Hot Cup uses.
Beware of accidentally operating the on/off switch. If you do, immediately
switch it off again.
If your Hot Cup has been switched on for more than 15 seconds, hot water will
still be dispensed. Do not attempt to move your Hot Cup from the base. Allow the
water to escape into the drip tray. Beware of hot water splashing from the drip tray.
If you have started the boil procedure and then decide to switch off your Hot
Cup, always allow it to stand for 1 minute before removing it from the power base
for refilling etc.
6