Installation; Non-Japanese/Japanese Cars; Removing Hard Rubber Frame; Removing Unit - Kenwood KDC-138 Instruction Manual

Installation

non-Japanese cars
Metal mounting strap
(commercially available)
Firewall or metal support
Self-tapping screw
(commercially available)
Screw (M4X8)
(commercially available)
⁄
• Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
Japanese cars
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and secure
the unit with the accessory screws.
T
N
8 mm
MAX.
3
ø5mm
ø5mm
Accessory3...for Nissan car
Accessory4...for Toyota car
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.
N
T/N
T
T: Toyota cars
N: Nissan cars
8mm
MAX.
4
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
Accessory2
Removal tool
2
When the upper level is removed, remove the
lower two locations.
⁄
• The frame can be removed from the bottom side in the
same manner.
Removing the Unit
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Remove the screw (M4 × 8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
4
Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
Screw (M4X8)
(commercially available)
Accessory2
¤
• Be careful to avoid injury from the catch pins on the
removal tool.
5
Pull the unit all the way out with your hands, being
careful not to drop it.
Lock
Catch
17
|
English