Basic Set Up - Sony KP-43T70K Service Manual

Connecting a Sony SAVA series
speaker system
Use this connection to control the speaker's
Dolby* Pro Logic surround system and
super woofer mode with the remote control.
(see "SAVA SP Control" on page 22)
1
Using the AUDIO cable supplied with the
speaker to AUDIO (VAR/FIX) OUT on
the projection TV.
2
Using the CONTROL S cable, connect
CONTROL S IN on the speaker to
CONTROL S OUT on the projection TV.
* Manufactured under license from Dolby
Laboratories Licensing Corporation.
Additionally licensed under Canadian patent
number 1,037,877. "Dolby," the double-D
symbol a and "Pro Logic" are trademarks of
Dolby Laboratories Licensing Corporation.

Basic Set Up

Using the Remote Control
Inserting the batteries
Insert two size AA (R6) batteries (supplied)
by matching the + and – on the batteries to
the diagram inside the remote control's
battery compartment.
Notes:
• Remove the batteries to avoid damage
from possible battery leakage whenever
you anticipate that the remote control
will not be used for an extended period.
• Handle the remote control with care.
Avoid dropping it, getting it wet, or
placing it in direct sunlight, near a heater
or where the humidity is high.
• Your remote control can be programmed to
operate most video equipment.
(see "Operating Video Equipment" on
page 30)
1 2
Disconnect all power sources before making any connections.
(Rear of projection TV)
IN
VIDEO 1 VIDEO 3
S VIDEO
VIDEO
L
(MONO)
AUDIO
CONTROL S
R
OUT
COMPONENT
CONTROL S
OUT
RK-G34, etc. (not supplied)
Setting Up the Projection TV
Automatically
The AUTO SET UP feature will allow you to
set the on-screen language and set all
receivable channels.
The AUTO SET UP feature does not apply for
installations that use a cable box for all channel
selection.
You can also set up the projection TV manually.
(see "Using the Channel Set Up menu" on pages
24 and 25)
Notes:
• Before you perform AUTO SET UP again,
make sure that the input from ANT (not
AUX) is selected by pressing ANT until
"AUX" does not appear next to the
channel number.
• Perform this function during the day, with
the antenna and/or cable properly
connected, to ensure that all available
channels will be broadcasting and
receivable.
• When you perform AUTO SET UP, all the
settings in the Video, and Audio menus
are reset to the factory settings.
– 12 –
OUT
AUDIO-L
MONITOR AUDIO
(VAR/FIX)
(white)
1 IN L
Y VIDEO
1
L
P
B (MONO)
AUDIO
P R
R
1 IN R
AUDIO-R (red)
Audio cord supplied
with the speakers
CONTROL S IN
Using the buttons on the front panel and
inside the drop-down panel on the projection
TV:
Front panel:
–
TV/VIDEO VOLUME
FLASH FOCUS
Inside the drop-down panel:
SET UP MENU
1
Press POWER to turn on the projection TV.
POWER
2
Press SET UP inside the drop-down panel.
The AUTO SET UP screen appears.
SET UP
SAVA series
speaker system
2
1 1
+ – +
POWER
CHANNEL
TIMER/STAND BY
TV/VIDEO
FLASH FOCUS
[ C H + ]
E n g l i s h :
E s p a ñ o l : [ C H – ]
F r a n ç a i s : [ V O L + ]
A u t o S e t U p : [ V O L – ]
First please connect
cable/antenna.
Press [ SET UP ] to exit.