System Connections - Kenwood D-R350 Instruction Manual

System connections

Caution:
4
Do not plug in the power lead until all connections are com-
pleted.
Make connections as shown below.
When connecting the related system components, refer also to the
instruction manuals of the related components.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer
dimensions including projections) equal to, or greater than, shown below.
Left and right panels: 10 cm
Digital component (MD, DAT, etc.)
To AC outlet
Audio cord
1. Connect all cords firmly. If connections are loose there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
Notes Notes
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Rear panel: 10 cm
(OPTICAL)
DIGITAL INPUT
(COAXIAL)
AC 110- AC 220-
120V 240V L
R
LINE OUTPUT
System control cord
CD
L
R
* The above illustration is simply an example.
The actual connected equipment may vary depending on the sales area.
Malfunction of microcomputer
If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the
microcomputer referring to "In case of difficulty".
Commercially-available
optical fiber cable
75 coaxial cable with RCA PIN.
(Commercially-available)
OPTICAL
COAXIAL
TEXT
SISTEM
CONTROL DIGITAL OUTPUT
Remove the protection cap when using
the DIGITAL OUTPUT (OPTICAL) jack.
SYSTEM
CONTROL
AV CONTROL CENTER (sold separately)
or receiver (sold separately)
AV CONTROL CERTER
D-R350 (En)
∞
To wall AC outlet