Troubleshooting For Anynet - Samsung 630 series Quick Setup Manual

¦

Troubleshooting for Anynet +

Problem
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet + .
The message 'Connecting to
Anynet+ device...' appears on
the screen.
The Anynet + device does not
play.
The connected device is not
displayed.
The TV program cannot be
recorded.
The TV sound is not output
through the receiver.
Possible Solution
Check if the device is an Anynet + device. The Anynet + system supports Anynet + devices only.
Connect only one receiver (home theater).
Check if the Anynet + device power cord is properly connected.
Check the Anynet + device's Video/Audio/HDMI 1.3 cable connections.
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
Check whether the TV remote control is in TV mode.
Check whether it is Anynet + exclusive remote control.
Anynet + doesn't work in certain situations. (Searching channels, Operating
Play, etc.)
When connecting or removing the HDMI 1.3 cable, please make sure to search devices again or
turn your TV off and on again.
Check if the Anynet + Function of Anynet + device is set on.
Check if the Anynet+ device is properly connected to the TV and check if the
+
CEC) is set to On in the Anynet
Press the TV button on the TV remote control to switch to TV. Then press the
show the Anynet + menu and select a menu you want.
in the Anynet + menu.
Select View TV
button on the TV remote control and select a device other than Anynet +
Press the SOURCE
devices.
Press z,
CH LIST, PRE-CH, and
channel button operates only when a tuner-embedded Anynet + device is not connected.)
You cannot use the remote control when you are configuring Anynet + or switching to a view
mode.
Use the remote control when the Anynet + setting or switching to view mode is complete.
You cannot use the play function when Plug & Play is in progress.
Check whether or not the device supports Anynet + functions.
Check whether or not the HDMI 1.3 cable is properly connected.
+
Check whether Anynet (HDMI-CEC)
Search Anynet + devices again.
You can connect an Anynet + device using the HDMI 1.3 cable only. Some HDMI cables may not
support Anynet + functions.
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power cord
or a power failure, please repeat the device scan.
Check whether the antenna jack on the recording device is properly connected.
Connect the optical cable between TV and the receiver.
English - 58
Setup menu.
FAV.CH to change the TV mode. (Note that the
in the Anynet + setup menu.
is set to On
Media Play, Plug &
+
Anynet (HDMI-
TOOLS button to