Displaying The Speaker Set Up Screen; Displaying The Channel Level Screen; High Pass Filter Setup - Kenwood DDX7025 Instruction Manual

unit.
Displaying the Speaker Set Up
screen
When the speaker type and size are set, the speaker
crossover network and equalizer curve are set
automatically.
Speaker Set Up screen
7
X ' Ov e r HPF
M e n u
Audio
8
X ' Ov e r LPF
Set Up
M u l t i C h a n n e l
10
3 / 2
SRC
F r o n t L&R
9
S t a n d a r d
11
S u b Woo f e r
13 Sp e a k e r
Displaying the Channel Level
screen
You can set the volume at each setup position.
Channel Level screen
M e n u
Audio
16
Set Up
T e s t
SRC
Ce n t e r
15
+ 1 0 dB
17
C h a n n e l
10
9
O f f
12
14
15
L e v e l
7 Displays the X'over (HPF) screen.
(See <High Pass Filter Setup>, page 54)
8 Display the X'over (LPF) screen.
(See <Low Pass Filter Setup>, page 54)
9 Sets up the front speaker type to fine-tune for the
optimal equalizer curves.
Standard: Setup for general diameter speakers
Narrow: Setup for small diameter speakers
Middle: Setup for small diameter woofer
Wide: Setup for large diameter woofer
p Select the speakers for Multi-channel sounds.
"3/2": Center speaker, Front speaker, Rear speaker
"2/2": Front speaker, Rear speaker
"3/0": Center speaker, Front speaker
"2/0": Front speaker
q Set the use or no use of Sub Woofer.
w Displays the Channel Level Setup screen.
e Displays the Car Type Set Up screen.
• "X'Over HPF" and "X'Over LPF" can be set only
when "Sub Woofer" is set to "On".
• To turn the Center speaker on in the "Multi
channel" settings, turn "Dolby Pro Logic" (see
page 83) on.
r Selects a speaker to be set.
(see <Channel Level>, page 52)
t Sets the speaker volume.
(see <Channel Level>, page 52)
y Starts or stops test signal tone output for setup
check.
u Displays the Speaker Set Up screen.
• Your setup on the <Sound Effects Menu> is
adjusted automatically to get the best sound
effects according to the car type and speaker you
have set on the <Audio Set Up> (see page 48).
We recommend you to complete the <Audio Set
Up> first, then set up the <Sound Effects
Menu>.
You can fine-adjust the automatic set value by
<DTA Setup> (see page 52) or <Parametric
Equalizer> (see page 80).
• Stop the test signal tone if you have finished
setting up the Channel Level. If you leave the test
signal tone on, you may not be able to set up
other settings.
English 51