Solar-Log Inverter Installation Manual page 207

Note
The inverter's factory setting is communication address 255.
► On the inverter operating display set the communication address manually to 1 even if
only one inverter is connected to the Solar-Log™.
S series:
► When setting the communication address on the inverter display only the RS485
interface must be activated (set at the factory), not the Ethernet interface that is also
installed in the inverter.
Note for feed-in management
The inverter itself has to be configured with MaxTalk2 (SolarMax's software) and set to
"Remote mode" to be able to use reactive power management. Please refer to the inverter
instructions for more information on this topic.
SolarMax – S, C, P, MT and HT series
SolarMax
207