Functional Description - Makita 3620 Instruction Manual

FUNCTIONAL
DESCRIPTION
1
2
1. Stopper pole
2. Screw
1
1. Lock lever
1
2
3
4
5
1. Depth pointer
2. Screw
3. Stopper pole
4. Adjusting hex bolt
5. Stopper block
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Adjusting the depth of cut
003252
Place the tool on a flat surface. Loosen the screw securing
the stopper pole.
Loosen the lock lever and lower the tool body until the bit just
003253
touches the flat surface. Tighten the lock lever to lock the tool
body.
Next, lower the stopper pole until it makes contact with the
003254
adjusting hex bolt. Align the depth pointer with the "0" gradu-
ation.
Raise the stopper pole until the desired depth of cut is
obtained. The depth of cut is indicated on the scale (1 mm or
1/16'' per graduation) by the depth pointer. Then tighten the
screw to secure the stopper pole.
Now, your predetermined depth of cut can be obtained by
loosening the lock lever and then lowering the tool body until
the stopper pole makes contact with the adjusting hex bolt.
CAUTION:
• Since excessive cutting may cause overload of the motor
or difficulty in controlling the tool, the depth of cut should
not be more than 15 mm (9/16") at a pass when cutting
grooves with an 8 mm (5/16") diameter bit. (Note: When
cutting grooves with a 20 mm (13/16") diameter bit, the
depth of cut should not be more than 5 mm (3/16") at a
pass.)
When you wish to cut grooves more than 15 mm (9/16")
7