Information - Sanyo DMP-P1 Instruction Manual

INFORMATION

Troubleshooting
If a fault occurs, first refer to this information before you take the device for repair. If you are
unable to rectify the fault using the information given here, contact Customer Support for
advice.
Under no circumstances should you attempt to repair the device yourself, as this would
invalidate the warranty.
PROBLEM
No Sound
The device does
not respond to
button commands
Poor radio
reception
Design and specifications are subject to change without prior notice
POSSIBLE CAUSE
Volume is too low.
Power cord incorrectly connected.
Electrical static discharge.
Weak radio signal
Interference from electrical devices
such as televisions,video recorders,
computers,neon lamps,etc.
REMEDY
Increase volume
Connect power cord correctly.
Switch off the device,disconnect
the mains cable and plug it in
again after a few seconds.
Extend the FM antenna to its full
length or try to change the
postion and direction of the FM
antenna.
Change the position of the unit
until it picks up the strongest
signal.
Move the unit away from the
other operating electrical
equipments such as motorized
appliances, televisions, and
microwave ovens.
14