Installation - Kenwood FM MODULATOR SYSTEM KCA-R70FM Instruction Manual

Installation

■
Installation of Display unit
• Installation without using the trim mount plate
Display unit
2
• Installation using the trim mount plate
Pass the wire from the display unit through the hole on the
trim mount plate and push fit the display unit into the trim
mount plate until it locks.
2CAUTION
• Be sure not to place the unit on such place as where it is
exposed to direct sunlight and temperature eventually rises.
It results in the deformation of the case.
• Depending on the installing location, the display unit may
not be able to receive the signals from the controller unit.
Install them after confirming that the signals can be
received.
• Install the unit in such a way that it does not disturb driving.
3
Attach one strip of Velcro to the
slanted-line of the the display
units as shown to the left, and
attach the other strip of Velcro
to the parts where you wish to
attach the display units.
Then, put velcros together and
install the display units.
3
Display unit
3
■
Installation of FM modulator unit
1
Install the FM modulator unit beneath the front seat using
Metal fixture and Bind head screw as shown in the above
figure.
— 20 —
2CAUTION
Take sufficient care so
that the wires are not
caught under the seat.
If they are caught, they
may break.
φ 3