Download  Print this page

Accessories; Installation Procedure - Kenwood FM MODULATOR SYSTEM KCA-R70FM Instruction Manual

Fm modulator system
Hide thumbs

Advertisement

Accessories

External view
1
................................................2
2
................................................1
3
................................................1
The use of any accessories except for those provided might result in
damage to the unit. Make sure only to use the accessories shipped with
the unit, as shown above.

Installation Procedure

1. To prevent a short circuit, remove the key from the ignition and
Number of items
2. Make the proper input and output wire connections for each unit.
3. Connect the wiring harness wires in the following order: ground,
4. Install the unit in your car.
5. Reconnect the - battery.
6. Press the reset button.
— 17 —
disconnect the - battery.
battery, ignition.
2WARNING
When drilling a hole in the car chassis to install the unit, check
first that nothing is on the other side.
2CAUTION
• If the fuse blows, first make sure the wires aren't touching to
cause a short circuit, then replace the old fuse with one with
the same rating.
• Do not let unconnected wires or terminals touch metal on the
car or anything else conducting electricity. To prevent a short
circuit, do not remove the caps on the ends of the
unconnected wires or the terminals.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
• Insulate unconnected wires with vinyl tape or other similar
material.
• Some disc changers require optional equipment for connection.
See the section on "Safety Precautions" for details.

Advertisement

loading

  Also See for Kenwood FM MODULATOR SYSTEM KCA-R70FM

  Related Manuals for Kenwood FM MODULATOR SYSTEM KCA-R70FM