Kenwood DNX5120 Instruction Manual: Help? Troubleshooting

Kenwood gps navigation system monitor with dvd-receiver instruction manual.
Hide thumbs
Help?
Troubleshooting
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
Subwoofer is not set to On.
(page 56)
Preout is set to "Rear".
60)
The Dual zone function is enabled.
Control> (page 84)
!
Cannot set up the subwoofer phase.
Subwoofer is not set to On.
(page 56)
Low pass filter is set to Through.
Network Setup> (page 57)
!
• Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
The Dual zone function is disabled.
Control> (page 84)
!
Cannot play audio files.
"CD Read" of <System Setup> (page 60) is set
to "2".
!
Cannot Folder select.
The Scan play or Random play function is
enabled.
!
Cannot perform Repeat play.
The PBC function is enabled.
!
• Cannot set up the equalizer.
• Cannot set up the crossover network.
The Dual zone function is enabled.
Control> (page 84)
!
Cannot watch the source selected as AV-OUT
in the rear monitor.
A source control screen is displayed in front.
<AV lnterface Setup> (page 62)
"AV-OUT Graphic Output" of <AV Interface
Setup> is set to "Black".
92
DNX5120/DNX512EX/DNX512EX/DDX512/DDX5032
<Audio Setup>
<System Setup> (page
<Zone
<Audio Setup>
<Crossover
<Zone
<Zone
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
?
The Touch Sensor Tone doesn't sound.
The preout jack is being used.
The Touch Sensor Tone can't be output from
the preout jack.
Tuner source
?
Radio reception is poor.
The car antenna is not extended.
Pull the antenna out all the way.
The antenna control wire is not connected.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
Disc source
?
The specified disc does not play, but another
one plays instead.
The specified disc is quite dirty.
Clean the disc.
The disc is severely scratched.
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
The media is scratched or dirty.
Clean the media, referring to the CD
cleaning of the section on <Handling discs>
(page 6).
The recording condition is bad.
Record the media again or use another
media.
Navigation
?
The touch panel control of the navigation
system does not work.
Navigation software is not the latest version.
Update the navigation software. For how to
update the software, refer to the instruction
manual of the navigation unit.

Advertising

   Related Manuals for Kenwood DNX5120

Comments to this Manuals

Symbols: 0
Latest comments:
  • constance evans Apr 08, 2013 03:33:
    how can I get a manual sent to me?
    kenwoo​d knx5120 please acknowledg​e this.
    than​k you