Tone Setup; Zone Control - Kenwood DNX5120 Instruction Manual

Audio Control

Tone Setup

You can set a Tone curve.
1 Display the Tone screen
See <Equalizer Control> (page 83).
2 Set the Tone
2
3
4
8
1 Tone curve becomes flat.
2 Bass adjustment items are displayed.
3 Middle adjustment items are displayed.
4 Treble adjustment items are displayed.
5 Sets the Center frequency.
6 Sets the level.
7 Sets the Q factor. (Only Bass and Middle can
be set)
8 Bass DC Extend settings (Only when Bass is
selected)
If turned "ON", it extends the bass
center frequency to the low register by
approximately 20%.
9 Returns to the "Equalizer" screen.
84 DNX5120/DNX512EX/DDX512/DDX5032
1
5
6
7
9

Zone Control

You can set the front and rear audio source.
1 Display Zone Control
Touch
Control Menu" screen (page 82).
1 Displays the current source.
2 Set the Zone Control
2
3
3
2 Turns the Zone Function (that sets different
source sounds for front and rear speakers)
On or Off.
3 Sets the front and rear audio source
separately.
(This button appears when the Zone
function is On.)
⁄
• When the rear speaker sound is switched, the audio
source that is output at the AV OUTPUT terminal is also
switched to the same source.
4 Adjusts the volume of the rear channel.
(This button appears when the Zone
function is On.)
⁄
• There are following limitations when zone function is set
to "On".
- There is no output from the subwoofer.
- <Audio Setup> (page 56) and <Equalizer Control>
(page 83) are not available.
- When "DVD" or "USB" is selected as the front source, the
rear source can be selected from "Front" (same source
as front), "iPod" or "VIDEO", etc. When the rear source is
in the "Audio
1
4