Routingtable; Route - D-Link NetDefend DFL-210 Cli Reference Manual

3.48. RoutingTable

3.48. RoutingTable
Description
The system has a predefined main routing table. Alternate routing tables can be defined by the user.
Properties
Name
Ordering
RemoveInterfaceIPRoutes
Comments

3.48.1. Route

Description
A route defines what interface and gateway to use in order to reach a specified network.
Properties
Name
Interface
Gateway
LocalIP
RouteMonitor
MonitorLinkStatus
MonitorGateway
MonitorGatewayManualARP
MonitorGatewayARPInterval
Specifies a symbolic name for the routing table. (Identifier)
Specifies how a route lookup is done in a named routing ta-
ble. (Default: Only)
Removes the interface routes. Makes the security gateway
completely transparent. (Default: No)
Text describing the current object. (Optional)
Specifies a symbolic name for the object. (Optional)
Specifies which interface packets destined for this route shall
be sent through.
Specifies the IP address of the next router hop used to reach
the destination network. If the network is directly connected
to the security gateway interface, no gateway address is spe-
cified. (Optional)
The IP address specified here will be automatically published
on the corresponding interface. This address will also be used
as the sender address in ARP queries. If no address is spe-
cified, the security gateway's interface IP address will be
used. (Optional)
Specifies if this route should be monitored for route changes
for route failover purposes. (Default: No)
Mark the route as down if the interface link status changes to
down. (Default: No)
Mark the route as down if the next hop does not answer on
ARP lookups during a specified time. (Default: No)
Enable a manually specified ARP lookup interval. (Default:
No)
Specifies the ARP lookup interval in milliseconds. (Default:
160
Chapter 3. Configuration Reference