Download  Print this page

Table Of Contents - Kenmore 625.347001 Owner's Manual

Reverse osmosis drinking water system
Hide thumbs

Advertisement

Tools and Materials Needed . . . . . . . . . . .
Installation Steps . . . . . . . . . . . . . . . . . . . .
Cold Water Supply Saddle Valve . . . . .
Drain Adapter . . . . . . . . . . . . . . . . . . . . .
Faucet . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RO Assembly . . . . . . . . . . . . . . . . . . . . . .
Storage Tank, Tubing Connections . . . .
-- WHAT YOUR REVERSE OSMOSIS SYSTEM WILL DO --
Your Reverse Osmosis (RO) Drinking Water System
is a water treatment unit. It uses household water
pressure to reverse a natural physical process called
osmosis. Water, under pressure, is forced through a
semi-permeable membrane where minerals and im-
purities are filtered out. Clean drinking water goes to
the faucet or storage, while minerals and impurities
are sent to the drain with RO waste water. The miner-
als and impurities are measured in water as total dis-
solved solids (TDS).
The system includes replaceable pre and postfilter
sediment-carbon cartridges. The prefilter removes
sand, silt, dirt, rust particles, other sediments, and
chlorine from the water supply before it can enter the
-- BEFORE YOU BEGIN TO INSTALL THE RO SYSTEM --
Check Your Water Supply: The cold water supply to
the RO system must be within certain quality limits.
See the specification table on page 15. If supply water
is not within limits, the RO system can not make
product water as it should and reduced RO mem-
brane life will result.
Trained salespeople at Sears can arrange for a free
water analysis. The analysis will tell you if other wa-
ter supply treatment is needed before going to the
RO system.
CAUTION: Chlorine in the water will destroy the
RO membrane. Most cities add chlorine to the wa-
ter supply to kill bacteria. The prefilter removes
chlorine up to the limits shown in the specifications
before it enters the RO membrane. It is important
to replace the prefilter cartridge at least every 6
months. See the RO care guide on page 14.
Check Parts Included: Unpack the carton and re-
move the RO system. In addition to the assembled

-- TABLE OF CONTENTS --

4
4
5- 9
5
6
6- 7
7
8
Installation Steps - continued
Sanitizing, Pressure Test, Purging . . . .
How the RO System Works . . . . . . . . . . .
Care of RO System . . . . . . . . . . . . . . . . . . . 11- 14
Dimensions, Specifications . . . . . . . . . . . .
Repair Parts . . . . . . . . . . . . . . . . . . . . . . . . . 16- 17
Remote Installation Locations . . . . . . . . .
RO membrane. The postfilter removes any tastes
and/or odors that may remain in the water, after
passing through the RO membrane, and just before
going to the RO faucet. To prevent water waste, an
automatic shutoff valve closes when the RO faucet is
closed and the storage tank is full.
Your reverse osmosis system gives you a continuous
supply of sparkling clear, delicious water for drink-
ing, cooking and other uses. Foods will look and
taste better too. Having high quality RO product wa-
ter at your fingertips eliminates the need to buy
bottled water. The storage tank holds over 2 gallons
of RO product water for your needs.
RO and the storage tank, the system includes the
parts illustrated below, a separate length of tubing,
and this manual.
FIG. 1
RO PRODUCT
WATER FAUCET
TUBING
ADAPTERS
3
WATER SUPPLY SADDLE VALVE
DRAIN
HANGER
ADAPTER
WASHERS &
SCREWS
9
10
15
18

Advertisement

Table of Contents
loading

  Related Manuals for Kenmore 625.347001

  Related Content for Kenmore 625.347001