Kenmore POWER MISER 153.32636 Owner's Manual page 12

Installation Instructions (cont'd)
Converting the Lower
Element (cont'd)
9. Replace terminal cover on thermostat making sure that the
locking tabs on the terminal cover are in place.
12. Complete wiring to the water heater, or if completed, turn
"ON" electric power to the water heater after filling the
tank with water.
_,WARNING
Make sure the thermostat is flush against the tank, the
terminal cover is in place, and the insulation is replaced.
Failure to do so can result in DEATH, SERIOUS BODILY
INJURY, OR PROPERTY DAMAGE.
10. Replace the insulation block and pad so that it completely
covers the thermostat and element.
CAUTION
Never use this water heater unless it is completely full of
water. To prevent damage to the tank and heating ele-
ment, the tank must be filled with water. Water must
flow from the hot water faucet before turning "ON"
power.
11. Replace the access panel.
12