Water Is Too Hot - Kenmore 153 Owner's Manual

2.
3.
4.
5.
6.
7.
Make sure the electrical supply to your water heater is
"ON".
Check for loose or blown fuses in your water heater circuit.
Circuit breakers weaken with age and may not handle
their rated load and should be replaced.
Make certain the disconnect switch, if used, is in the "ON"
position.
Check to see the electric service to your house has not
been interrupted. If this is the case, contact the electric
company.
Is the thermostat set to the desired temperature? See
"Temperature Regulation" section.
If you had experienced very hot water and now no hot
water, the problem may be due to the high temperature
shut off system. See "High Temperature Shut Off System"
in the "Troubleshooting" section.
8. During very cold weather, the incoming water will also be
colder and it will require a longer time to become heated.
g.
The hot water usage may exceed the capacity of the water
heater. If so, wait for water heater to recover after abnormal
demand. Also examine pipes and faucets for possible
water leaks.
10. If you can not determine the problem, then call the Sears
Service Department.
WATER IS TOO HOT
Adjust the thermostat to a lower setting. See the "Temperature
Regulation" section.
25