Kenmore ULTRAFILTER 300 625.384720 Owner's Manual page 7

- STEP 3: INSTALL FAUCET (cont.)-
..* SEM.LEF*UCET [FIG. 6]
1. Remove the large blue nut from the faucet threads.
2. Slide the three attached tubes and the telephone
style wire (monitored models only) through the sink
or countertop hole, aligning gasket under faucet
base.
3. On the underside of the sink or countertop, screw
the nut on the faucet threads with the tubing and
wire running through the center hole of the nut.
Tighten the nut so the faucet cannot move, but do
not overtighten.
ASSEMBLED IN
MOUNTING HOLE
faucet & spout
4. CONNECT TUBING TO FAUCET AS FOLLOWS.
a. Using the 3/8" x 1/4" tubing adaptor, connect
the 1/4" blue tubing from the faucet to the 3/8" blue
tubing from the RO.
Note: See pages 13 and 14 for tubing connection in-
structions.
b. Using the 1/4" x 1/4" tubing adaptor, connect
the 1/4" red tubing from the faucet to the 1/4" red
tubing from the RO.
c. Monitored models only: Connect the telephone
style wire to the receptacle on PWA board in the RO
manifold and route the wiring through holes in top
cover and manifold assembly.
- STEP 4: INSTALL RO
ASSEMBLY -
hole in sink or_
countertop
318" black tubing
to drain point
telephone
style wire
\
tubing adapters-_o.,@
3/_" blue
tubing
TUBING FROM
RO SYSTEM
FIG. 7
]
hoager
washer (2).
screw (2) __
gasket
/
plumbers putty
/
1/4" red
tubing
tubing
nut
114" red tubing
from RO drain
7.2" (appr_ 7- 7/32")
Hang the assembly on the included hanger washers,
or lay on the cabinet floor, as desired.
1. Refer to FIG. 7 for wall mounting. Hold the assem-
bly up to the wall surface and mark locations for the
hanger washers. Distance needed is 7.2" (approx.
7-7/32") apart.
15-1/2 '_
rrlirl.
up from
floor
2. Install hanger washers at least 15-1/2" up from the
cabinet floor, allowing room to remove sumps from
filter heads. Wood screws are provided, or obtain
other fasteners as needed.
7
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line