Tuner; Tuning To A Station; Using Presets; Auto Preset Program - RCA RS3532 User Manual

Tuner

EN
DISC SKIP OPEN/CLOSE
BAND/
SOURCE DECK 1/2
AUTO PROG.
1
DISC
1. Press SOURCE to select TUNER.
2. Press BAND to select between AM or FM radio
band.
Tip: Your audio system has 32 preset stations.

Tuning to a Station

Press SKIP FORWARD/ BACKWARD to select fre-
quencies.

Using Presets

The tuner can be either
TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
Press SKIP BACKWARD or SKIP FORWARD on the
main system or PRESET UP or DOWN on the remote
control to access the previous or next preset station.
The display first shows the preset program number
and after a few seconds, the frequency and preset
program number will be displayed. (FMPR:01 is FM
preset 1)
Auto Preset
Programming
(for FM only)
Press and hold BAND
button for 2 seconds to scan stations in the FM band.
The stations will then be stored as preset channels. A
maximum 32 stations can be stored. Beware of your
preset channels being erased accidentally because the
scanning and storing process is automatic upon press-
ing the button. You can stop the automatic scan by
pressing any button, but the erased stations cannot be
recovered.
8
ROCK/CLASSIC CUSTOM/FLAT POP/JAZZ
TUNE/PRESET
KEVLAR/WOOFER/
EQ CONTROL
X-SURROUND
DIRECT DISC ACCESS
2 3 4 5
DISC DISC DISC DISC
87.50 MH
PR:01
VOLUME
Manually Setting Presets
1. Select Tune using the PRESET/TUNE button. FM or
AM should appear before the frequency.
2. Press SKIP FORWARD/ BACKWARD to access the
desired frequency.
3. Press the SET button once.
4. The most recently accessed program location will
be displayed.
5. If a different program location is preferred, press
SKIP BACKWARD / FORWARD to move to the
desired preset number (1-32).
6. Press SET to store the selected frequency at that
preset.

Suppressing Stereo Signal

Press FM ST to toggle between FM mono and stereo
for stereo FM stations. (Remote Only)
z