Advertisement
Quick Links
Kenmore
Pre-lnstallation
Requirements
..........................
2
Electrical
Requirements
.....................................
2
Grounding
Requirements
.................................
2
Water Supply Requirements
..............................
2
Drain Requirements
..........................................
2
Rough-In
Dimensions
..........................................
3
Location Of Your Washer
..................................
4
Unpacking
.........................................................
4
Installation .........................................................
5
Tumble ActionWasher.
Replacement
Parts .............................................
5
Before beginning installation, carefully read these instructions. This will simplify the installation
and ensure the washer is installed correctly and safely. Leave these instructions near the
washer after installation for future reference.
NOTE: The electrical service to the Washer must conform with local codes and ordinances
and the latest edition of the National Electrical Code, ANSI/NFPA 70.
Save These Instructions
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
P/N 131801800
(9811)
Advertisement
Related Manuals for Kenmore 131801800
Summary of Contents for Kenmore 131801800
- Page 1 Tumble ActionWasher. Before beginning installation, carefully read these instructions. This will simplify the installation and ensure the washer is installed correctly and safely. Leave these instructions near the washer after installation for future reference. NOTE: The electrical service to the Washer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70.
-
Page 2: Grounding Requirements
WATER Hot and cold water faucets MUST be installed within 42 inches (107 cm) of your washer's water inlet. The faucets MUST be 3/4 inch (1.9 cm) garden hose type so inlet hoses can be connected. Water pressure MUST be between 10 and 120 pounds per square inch (maximum unbalance pressure, hot vs. -
Page 3: Undercounter Installation
24 ¾ (62.9) (5.1) [_ SIDE inch (cm) Adjustable Legs If an under counter* installation is desired, the washer MUST have a top sheet kit installed, P/N 131445600. Kit is available from Sears Parts Department. (43.2)-_ 24 ¾ "_-- (62.9) _ SIDE •... - Page 4 10. Remove and discard the yellow ribbon and label from the front of the washer. 11. From the rear of the washer, carefully pull out the power supply cord through the hole in the backsheet.
-
Page 5: Installation
Use only new hoses provided with this unit. Carefully move the washer to its final location. Rollers on the rear of the washer allow for easy movement in undercounter installations. Gently lift up on the front of the washer and slide back.