Table of Contents
Advertisement
1. Checking for no Picture
A screen doesn't display at all and condition of black pattern or power off.
(1) Check whether the CTRL B/D LED(D10, D11, D12, D13, D17) is turned on or not.
(2) Check the power and signal cable of CTRL B/D.
(3) X B/D, Y B/D, Z B/D is well plugged in.
(4) Check the connection of X B/D, Y B/D and Z B/D to CTRL B/D.
(5) Measure the output wave of X, Y, Z B/D with oscilloscope(more than 200MHz)
and find the trouble of B/D by comparing the output wave with below figure.
- Measure Point fo Y B/D : TP(Bead B103)
- Measure Point fo Z B/D : TP(Bead B37)
- Measure Point fo X B/D : COF TP
(6) Check the SCAN(Y side) IC
(7) Check the DATA(X side) COF IC
(8) Replace the CTRL B/D.
¥†. Trouble Shooting
- 10 -
<A: Y B/D Output wave - 1 FRAME>
<B: Y B/D Output wave - 1 SF>
Advertisement
Table of Contents
