Periodic Maintenance Procedures
Install the anti-rattle springs [A] in the caliper as shown.
Replace the shaft rubber boot [A] and dust boot [B] if they
Apply a thin coat of PBC (Poly Butyl Cuprysil) grease to
the caliper holder shafts [C] and holder holes (PBC is a
special high temperature, water-resistance grease).
Install the pads (see Brake Pad Installation in the Brakes
Install the caliper (see Caliper Installation in the Brakes
Wipe up any spilled brake fluid on the caliper with wet
PERIODIC MAINTENANCE 2-45