2-24 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Cylinder Wear Inspection
Measure the cylinder inside diameter when the cylinder
is cold (room or ambient temperature).
Visually Inspect the inside of the cylinder for scratches
and abnormal wear.
If the cylinder is damaged or badly worn, replace it with a
Since there is a difference in cylinder wear in different di-
rections, take a side-to-side and a front-to-back measure-
ment shown in the figure.
[A] 10 mm (0.39 in.)
[B] 30 mm (1.2 in.)
[C] 50 mm (2.0 in.)
If any of the cylinder inside diameter measurements ex-
ceeds the service limit, the cylinder must be replaced with
a new one since the PLATING cylinder cannot be bored
Cylinder Inside Diameter
96.000 ∼ 96.012 mm (3.7795 ∼ 3.7800
96.025 ∼ 96.037 mm (3.7805 ∼ 3.7810
96.10 mm (3.783 in.)**
96.12 mm (3.784 in.)**
*: less than 0.01 mm (0.0004 in.) difference between any
**: less than 0.05 mm (0.020 in.) difference between any
Piston/Cylinder Clearance Inspection
The piston-to-cylinder clearance is measured whenever a
piston or cylinder is replaced with a new one. The standard
piston-to-cylinder clearance must be adhered to whenever
the cylinder is replaced.
If only a piston is replaced, the clearance may exceed the
standard slightly. But it must not be less than the minimum,
in order to avoid piston seizure.
The most accurate way to find the piston clearance is
by making separate piston and cylinder diameter measure-
ments and then computing the difference between the two
values. Measure the piston diameter as just described, and
measure the cylinder diameter at the very bottom of the
0.020 ∼ 0.042 mm (0.00079 ∼ 0.0016 in.)
0.050 ∼ 0.062 mm (0.0020 ∼ 0.0024 in.)