16-14 ELECTRICAL SYSTEM
Magneto Cover Removal
Drain the engine oil (see Engine Oil Change in the Peri-
odic Maintenance chapter).
Remove the left radiator shroud (see Radiator Shroud Re-
moval in the Frame chapter).
Disconnect the magneto lead connector [A] from the main
Open the clamp [A] then free the breather hose [B].
Magneto Cover Mounting Bolts [C].
Magneto Cover [D]
Magneto Cover Installation
Replace the gasket [A] with a new one.
Be sure to install the dowel pins [B].
Apply silicone sealant to the area [A] to the magneto lead
Sealant - Liquid Gasket, TB1211F: 92104-0004
Put in the magneto lead to the lead holder [A].
Torque - Magneto Cover Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Run the breather hose [B] and magneto lead according
the Cable, Wire, and Hose Routing section in the Appen-
Connect the magneto connector.