Tie-Rod, Rocker Arm
Tie-Rod and Rocker Arm Bearing Installation
Replace the needle bearing and grease seals with new
Apply plenty of grease to the grease seal and needle
Install the grease seals so that the deep groove side of
the rip out-ward.
Install the needle bearings [A], [B] and grease seals [C]
position as shown.
The installation procedure is the same as the counter
[D] 1 mm (0.04 in.)
[E] 2.5 mm (0.098 in.)
[F] 4.25 mm (0.167 in.)
Needle Bearing Inspection
Do not remove the bearings for inspection. Re-
moval may damage them.
Inspection the needle bearings installed in the rocker arm.
The needle bearing normally wear very little, and wear
is difficult to measure. Instead of measuring, visually in-
spect the bearings for abrasion, discoloration, or other
If there is any doubt as to the condition of either needle
bearing, replace the bearing and sleeve as a set.
[G] 4.5 mm (0.18 in.)
Rocker Arm [J]