Step on the side of the tire opposite valve stem, pry the
tire off the rim with the tire irons [A] of the bead breaker
protecting the rim with rim protectors [B].
Begin to remove the tire beads from the rim, and com-
pletely remove the tire beads that are valve stem of the
opposite side, and then remove the tire beads slowly.
Take care not to inset the tire irons so deeply that
the tube gets damaged.
Special Tools - Rim Protector: 57001-1063
Bead Breaker Assembly: 57001-1072
Remove the tube.
Separate the beat stopper.
Remove the tire beads of the opposite side, and separate
the rim from the tire.
Remove the rim protectors.
The Tires should be installed so that the ID serial NO.
[A] faces to left side.
Inspect the rim and tire, and replace them if necessary.
Install the tube band and tube.
Apply a soap and water solution, or rubber lubricant to the
rim flange and tire beads.
When the tire is installed, position the tire on the rim so
that the valve stem [A] is at the tire balance mark [B]
(marked on the tire with chalk the yellow paint mark on
a new tire).
Insert the valve stem into the rim, and screw the nut on
Fit the rim protectors and use tire irons to install the tire
To prevent rim damage, be sure to place the rim protec-
tors at any place the tire irons are applied.
Pry one side of the tire back onto the rim. Fit the bead
protector into the tire.
Pry the other side of the tire onto the rim, starting at the
side opposite the valve.
Take care not to insert the tire irons so deeply that the
tube is damaged.
Install the other side of the tire bead onto the rim in the
Check that the tube is not pinched between the tire and