Install the friction plates and steel plates, starting with a
friction plate [A] and alternating them. Finishing with a
When install the new plate, apply engine oil to the plate
Install the friction plates which the lining blocks [B] on the
plates installed to both end are more than the one of the
Install the both ends marked two friction plates at disas-
sembled to the their original position.
When replace the friction plates with new ones, mark the
both end two friction plates so that the two kinds of friction
plates do not mix up at opening the package.
If dry steel plates and friction plates are installed,
apply engine oil to the surfaces of each plate to
avoid clutch plate seizure.
Apply molybdenum disulfide grease to the sliding portion
[A] of the push rod holder.
Install the push rod [B] and push rod holder.
Apply molybdenum disulfide grease to the needle bearing
[C] and washer [D], and install them.
Install the clutch spring plate [A].
Torque - Clutch Spring Bolts [B]: 8.8 N·m (0.90 kgf·m, 78
Install the clutch cover (see Clutch Cover Installation).