Clutch Lever and Clutch Cable
Loosen the adjusting nuts [A] fully.
Free the clutch inner cable tip [B] from the clutch release
Do not remove the clutch release shaft unless it is
absolutely necessary. If removed, release shaft oil
seal must be replaced with a new one.
Pull the clutch cable out of the frame.
Clutch Cable Installation
Install the clutch cable with the threads width as shown.
[A] 5 ±2 mm (0.2 ±0.08 in.)
Run the clutch cable correctly (see Cable, Wire, and Hose
Routing section in the Appendix chapter).
Adjust the clutch cable (see Clutch Lever Free Play Ad-
justment in the Periodic Maintenance chapter).
Clutch Cable Inspection and Lubrication
During a periodic inspection or when the cable has been
removed, inspect and lubricate the cable (see General
Lubrication and Cable Inspection in the Periodic Mainte-