1. Unplug cord from wall outlet. DO NOT
drip water on cleaner.
2. Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry.
Wipe dry after cleaning.
3. To reduce static electricity and dust build-
up, wipe outer surface of vacuum cleaner
Do not use attachments
are wet. Attachments
dirty areas, such as under a
should not be used
on other surfaces until they are
could leave marks.
Check motor safety filter occasionallyand
change when dirty.
Unplug power cord from electrical
outlet. Do not operate the vacuum
cleaner without the motor safety
filter, Be sure the filter is dry and
properly installed to prevent motor
failure and/or electrical shock.
Remove the bag as outlined in the BAG
MOTOR SAFETY FILTER
This filter must be replaced when dirty. It
should be replaced regularly depending on
use conditions. The filter CANNOT be
washed as it will lose its dust trapping
NOTE: See PARTS AND FEATURES for
motor safety filter number.
1. Lift the rubber
retainer and pull
out motor safety
filter as shown.
2. Replace the fil-
ter, white side out,
facing the dust bag,
by sliding it back
into place under
the ribs in the bag
cavity. Tuck filter in
so that it fits com-
pletely under the
3. Replace the bag as outlined in the BAG