Table of Contents
Advertisement
Available languages
Available languages
•
Do not ground to a gas pipe.
•
Check with a qualified electrician if you are not sure the
washer is properly grounded.
•
Do not have a fuse in the neutral or ground circuit.
1
2
...........................
................
3
1.3 prong grounding plug
2. 3 prong grounding-type
wall receptacle
3. Grounding prong
4. Power supply cord
GROUNDING
mNSTRUCTmONS
For a grounded,
cord-connected
washer:
This washer
must be grounded.
Hnthe event of a
maHfunction
or breakdown,
grounding
wHHreduce
the
risk of eHectricaH shock by providing
a path of Heast
resistance
for eHectric current.
This washer
is
equipped
with a cord having
an equipment-grounding
conductor
and a grounding
pHug. The pHug must be
pHugged into an appropriate
outHet that is properHy
instaHHed and grounded
in accordance
with aHH HocaH
codes and ordinances.
WARNING:
Hmproper connection
of the
equipment-grounding
conductor
can resuHt in a risk of
eHectric shock. Check with a quaHified eHectrician or
serviceman
if you are in doubt as to whether
the
appHiance is properHy grounded.
Do not modify the pHug provided
with the appHiance -
if it wiHH not fit the outHet, have a proper outHet instaHHed
by a quaHified eHectrician.
For a permanentJy
connected
washer:
This washer
must be connected
to a grounded
metaH,
permanent
wiring system,
or an equipment
grounding
conductor
must be run with the circuit
conductors
and
connected
to the equipment-grounding
terminaH or
Head on the appHiance.
INSTALLATION
INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install
washer.
Failure to do so can result in back or other injury.
IMPORTANT: Position the washer so that the rear of the unit is
within approximately
3 ft (90 cm) of the final location.
There are 4 bolts in the rear panel of the washer that support the
suspension system during transportation.
These bolts also retain
the power cord inside the washer until the bolts are removed.
1.
2.
Using a 13 mm wrench, loosen each of the bolts.
Once the bolt is loose, move it to the center of the hole and
completely pull out the bolt, including the plastic spacer
covering the bolt. The power cord will be attached to all
4 bolts inside the washer.
3. Once all 4 bolts are removed, pull the power cord through the
opening of the rear panel and close the hole with the attached
cap.
4. Close the bolt holes with the 4 transport bolt hole plugs.
NOTE: If the washer is to be transported
at a later date, call
your local service center. To prevent suspension and structural
damage, your machine must be properly set up for relocation
by a certified technician.
Hide quick links:
Advertisement
Chapters
Table of Contents
