Connections With The Tv Or Audio - Toshiba D-VR6KC Owner's Manual

Connections with the TV or audio component
Connect to a TV with HDMI output
HDMI stands for High Definition Multimedia Interface. HDMI transfers digital audio and uncompressed digital
video on a single cable. As a result, audio cables and video cables don't need to be connected separately to a
device. In addition, HDMI is compatible with HDCP (High Bandwidth Digital Content Protection).
To HDMI OUT
NOTES:
• Refer to the owner's manual for the TV to be connected to this recorder for more information concerning
HDMI connections.
• HDMI is an evolving technology, so it is possible that some devices may not operate properly with this recorder.
• No sound will be output from the HDMI OUT jack if the "DOLBY DIGITAL OUTPUT" is not set to "PCM" (see
page 32).
Switching the output signals (HDMI/Progressive)
1. Turn ON the TV and set to the appropriate input mode (HDMI or Component).
2. Press PROG/HDMI on the remote control to change the video output signals (HDMI/Progres-
sive) as below.
The content of the output for each ouput jacks are as shown in the following table and differ
depending on output setting.
Mode
VCR/DVD
DVD
VCR
* When the HDMI/Progressive is active, it is impossible to output any video images from the Video out jack and
S-Video out jack. In this case, press PROG/HDMI repeatedly to switch the HDMI/Progressive output setting to
"OFF" or set the TV to Component input mode/HDMI input mode.
NOTES:
• PROG/HDMI button is not available in VCR mode.
• 720p and 1080i are available when the unit is connected to the HDMI-compatible display.
• When the HDMI mode is active, the HDMI indicator "HD" on the display window will light up.
• If the HDMI cable is disconnected when the HDMI mode is active, the HDMI indicator "HD" on the display
window will flash. In this case, press PROG/HDMI repeatedly to switch the HDMI output setting to "OFF", or
connect the HDMI cable again.
• When the progressive mode is active, the Progressive indicator "
• When the HDMI mode is active, you cannot use Dubbing function (see pages 78 and 79).
• If your TV is not compatible with progressive scan, press and hold the STOP button on the front panel for
about 3 seconds to return to normal picture.
2J41101B_E P12-22
For proper operation, it is recommended that you use
as short an HDMI cable as possible.
HDMI Cable (not supplied)
HDMI
OFF
480p (Progressive)
720p (Progressive)
1080i (Interlace)
HDMI/Progressive
Output setting
HDMI
OFF -
480p 480p
720p 720p
1080i 1080i
OFF -
480p 480p
720p
720p
1080i 1080i
21
Component
480i (Interlace)
480p (Progressive)
480p (Progressive)
480p (Progressive)
Content of output for each output jack
Video S-Video
480i 480i
- -
* *
- -
* *
- -
* *
480i 480i
480i -
480i -
480i -
" on the display window will light up.
P
5/28/07, 12:03 PM
HDMI-compatible
display
To HDMI input
Component
480i
480p
480p
480p
480i
480p
480p
480p
21