Setting Oven Controls - Kenmore ELITE 790.3671 Series Use & Care Manual

Setting Oven Controls
Setting the Clock
The CLOCK _ pad is used to set the clock. The dock may be set for 12 or 24 hour
time of day operation. The clock has been preset at the factory for the 12 hour
operation. When the range is first plugged in, or when the power supply to the range
has been interrupted, the timer in the display will flash with "PF" (power failure, See
Figure 1).
When PF appears in the display, press _. No sound will be heard, but after 10 seconds
a beep will sounds and PF will disappear.
INSTRUCTIONS
To set the clock (example: 1:30)
1. Press _.
"CLO" will appear in the display (Figure 2).
2. Press (_ (_ (_ pads to set the time of day to 1:30
(Figure 3). "CLO" will stay in the display. Press _r_. "CLO"
will disappear and the clock will start (Figure 4).
PRESS
Q
OQQ
Changing between 12 or 24 hour time of day display
1. Press and hold _ for 7 seconds (Figure 3). CONTINUE
holding the pad until "12Hr" (Figure 4) or "24Hr" (Figure 5)
appears in the display.
Press _ to switch between the 12 and 24 hour time of
2.
day
display. The display will show either "12Hr" (Figure 4) or "24Hr"
(Figure 5).
3. Press <A_ to accept the desired change or press @ to
reject the change.
4. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
Q
for 7 seconds
Q
Figure 1
DISPLAY
Figure 2
Figure 3
:'itt _
Figure 4
Figure 5
17