Download  Print this page

Daikin RXYQ5PY1 Service Manual Page 322

R-410a heat pump 50hz/60hz cooling only 50hz.
Hide thumbs

Advertisement

SiEN34-705
Press air flow direction adjust button.
5
Refer to the chapter "Adjusting the air flow direction" for
details.
STOPPING THE SYSTEM (Refer to figure 4)
Press the on/off button once again.
6
The operation lamp goes off and the system stops operation.
Note
• Do not turn off the power immediately after the unit stops.
• The system need at least 5 minutes for residual operation
of drain pump device.
Turning off the power immediately will cause water leak or
trouble.
EXPLANATION OF HEATING OPERATION (except RXQ series)
• For general heating operation, it may take longer to reach the set
temperature than in cooling operation.
We recommend starting the operation which was used before
using timer operation.
• The following operation is performed in order to prevent the heat-
ing capacity from dropping or cold air from blowing.
Defrost operation
• In heating operation, freezing of the outdoor unit heat
exchanger increases. Heating capability decreases and the
system goes into defrost operation.
• The indoor unit fan stops and the remote control displays
"
".
• After maximum 10 minutes of defrost operation, the system
returns to heating operation again.
Hot start
• In order to prevent cold air from blowing out of an indoor
unit at the start of heating operation, the indoor fan is auto-
matically stopped. The display of the remote control shows
"
".
Note
• The heating capacity drops as the outside temperature falls. If this
happens, use another heating device together with the unit.
(When using the appliances which produce open fire together,
ventilate a room constantly.)
Do not place appliances which produce open fire in places
exposed to the air flow from the unit or under the unit.
• It takes some time for the room to warm up from the time the unit
is started since the unit uses a hot-air circulatory system to warm
the entire room.
• If the hot air rises to the ceiling, leaving the area above the floor
cold, we recommend using the circulator (the indoor fan for circu-
lating air). Contact your dealer for details.
1-6-2 Program Dry Operation
• The function of this operation is to decrease the humidity in
your room with a minimum temperature decrease.
• The micro computer automatically determines temperature
and fan speed.
• The system does not go into operation if the room temper-
ature is low.
• The microcomputer automatically controls the temperature
and fan speed, so these cannot be set using the remote
control.
• This function is not available if the room temperature is
20°C or lower.
FOR SYSTEMS WITHOUT COOL/HEAT SELECTOR (Refer to
figure 5)
figure 5
Press the operation mode selector button several times and
1
select "
" ( program dry operation).
Operation Manual
Press the on/off button.
2
The operation lamp lights up and the system starts operation.
Press the air flow direction adjust button (only for FXC, FXF,
3
FXH, FXK, FXA). Refer to the chapter "Adjusting the air flow
direction" for details.
Press the on/off button once again.
4
The operation lamp goes off and the system stops operation.
Note
• Do not turn off the power immediately after the unit stops.
• The system need at least 5 minutes for residual operation
of drain pump device.
Turning off the power immediately will cause water leak or
trouble.
FOR SYSTEMS WITH COOL/HEAT SELECTOR (except RXQ
series) (Refer to figure 8)
Select cooling operation mode with the Cool/Heat selector.
1
Press the operation mode selector button several times and
2
select program dry "
Press the on/off button.
3
The operation lamp lights up and the system starts operation.
Press the air flow direction adjust button (only for FXC, FXF,
4
FXH, FXK, FXA). Refer to the chapter "Adjusting the air flow
direction" for details.
Press the on/off button once again.
5
The operation lamp goes off and the system stops operation.
Note
• Do not turn off the power immediately after the unit stops.
• The system need at least 5 minutes for residual operation
of drain pump device.
Turning off the power immediately will cause water leak or
trouble.
1-6-3 Adjusting the Air Flow Direction (Refer to figure
6) (only for Double-flow, Multi-flow, Corner, Ceil-
ing-suspended and Wall-mounted)
Press the air flow direction button to select the air
1
direction.
The air flow flap display swings as shown right
and the air flow direction continuously varies.
(Automatic swing setting)
Press the air flow direction adjust button to select
2
the air direction of your choice.
Operation Manual
figure 8
".
figure 6
315

Advertisement

   Related Manuals for Daikin RXYQ5PY1

Comments to this Manuals

Symbols: 0
Latest comments:
  • GMacD Dec 22, 2015 11:58:
    Your website is crap in providing useful informatio​n on your products.