Download  Print this page

Advertisement

4. Press the ↑, ↓, ←, and → buttons of a remote
controller and click the "Next" button. Press the Enter
button.
The ISDN setting wizard is displayed when ISDN unit
PCS-B384 or PCS-B768 is connected.
The LAN setting wizard is displayed when an ISDN
unit is not connected. Proceed to step 11.
5. Set the country, region, and protocol in which an
ISDN line is used.
Country/region:
Select the country or region in which this unit is used.
Select "Japan" when you use this unit in Japan.
Country/region No.:
Enter the country, region's national number, or region
number in which this unit is used.
Enter "81" when you use this unit in Japan. ("81" is
automatically displayed when you select "Japan" in
"Country/region".)
Protocol:
Select the protocol of the ISDN line used. Select
"NTT" when you use this unit in Japan.
6. Press the ↑, ↓, ←, and → buttons of a remote
controller and click the "Next" button. Press the Enter
button.
7. Enter the telephone number of an ISDN line that this
unit uses.
For one line, enter the same number in columns A1
and A2.
Area Code
A1
A2
B1
B2
C1
C2
Previous
Area code:
Enter the area code.
Do not enter the first "0" of an area code.
Local code:
Enter the local code.
n
Select a blank column and press the Enter button of a
remote controller. The setting contents of an item in
the above column are then copied.
PCS-1/1P
Local Number
Next
Cancel
n
During use of ISDN unit PCS-B384, enter telephone
numbers in columns B1 to C2 when two or three ISDN
lines are connected.
During use of ISDN unit PCS-B768, enter telephone
numbers in columns B1 to F2 when two to six ISDN
lines are connected. To display columns D1 to F2,
select "Next" and press the Enter button.
8. Press the ↑, ↓, ←, and → buttons of a remote
controller and click the "Next" button. Press the Enter
button.
9. Enter a sub-address.
In the sub-address, only numeric characters are valid.
For one line, enter the same number in columns A1
and A2.
Sub Address
A1
A2
B1
B2
C1
C2
Previous
n
During use of ISDN unit PCS-B384, enter sub-
addresses in columns B1 to C2 when two or three
ISDN lines are connected.
During use of ISDN unit PCS-B768, enter sub-
addresses in columns B1 to F2 when two to six ISDN
lines are connected. To display columns D1 to F2,
select "Next" and press the Enter button.
10. Press the ↑, ↓, ←, and → buttons of a remote
controller and click the "Next" button. Press the Enter
button.
The LAN setting wizard is then displayed.
n
When you do not use LAN, select "Next" and display
a confirmation message. After that, proceed to step
13.
Next
Cancel
1-15

Advertisement

Table of Contents

This manual is also suitable for:

Pcs-1p

Comments to this Manuals

Symbols: 0
Latest comments: