Troubleshooting - Kenmore 758.15408 Operator's Manual

8 gallon output with digital readout whole house humidifier
Table of Contents

Advertisement

Available languages

Available languages

Troubleshooting,
Trouble
Probable Cause
Remedy
Digital display not illuminated.
• No Power.
• Check 120 volt power source.
• Power button has not been
• Press power button once to
depressed,
turn on.
Fan not operating (digital
• ROOM humidity level is not
• Raise SET humidity level if
display is illuminated).
3% or more below SET
desired.
humidity level.
• Reservoir is empty.
• Increase fan speed.
• Fill humidifier with water.
Fan running continuously.
• SET humidity level is 65%.
• ROOM humidity level has not
reached 1% or more above
SET humidity level.
• A SET humidity percentage
of 65% operates fan
continuously. Adjust SET
level between 25% - 60%.
• Continue to run until desired
humidity level is achieved.
This may take up to 48 hours
initially.
Poor evaporation
of water.
• CHECK FILTER message
• Change to a fresh new
flashing,
filter.
• Mineral buildup on filter.
NOTE: Local water purity
varies from area to area.
Bottle empties completely.
• This is normal for initial filling.
• Refill bottle for maximum run
time.
Bottle continues to empty
• Air is entering water bottle.
• Check for leak in water bottle.
after complete filling.
Bottle not emptying.
• Spring Valve Assembly
damaged or missing post
in bottom of base.
• Base full of water.
• Check orientation of bottle.
Reposition so that fill valve on
bottom of bottle is depressed
by post in bottom of base.
• The base will hold the
contents of water bottle (1.2
gallons). Continue to run
humidifier to deplete water
from base.
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

758.154080

Table of Contents