Toshiba PORTEGE A200 series Maintenance Manual page 124

3 Tests and Diagnostics
3. The Hard Disk Test message will appear after you respond to the Detail Status prompt.
Select the number of the subtest you want to execute and press Enter. The following
message will appear during each subtest.
HARD DISK TEST XXXXXXX
SUB TEST
PASS COUNT
WRITE DATA
ADDRESS
The first three digits of the ADDRESS indicate which cylinder is being tested, the fourth
digit indicates the head number and the last two digits indicate the sector number.
The first digit of the STATUS indicates the drive being tested and the last two digits indicate
the error status code as explained in the table 3-2 of the section 3.18.
Subtest 01 Sequential read
This subtest is a sequential reading of all the tracks on the HDD starting at track 0.
When all the tracks on the HDD have been read, the test starts at the maximum
track and reads the tracks on the HDD sequentially back to track 0.
Subtest 02 Address uniqueness
This subtest writes unique address data to each sector of the HDD track-by-track.
The data written to each sector is then read and compared with the original data.
There are three ways the HDD can be read:
1. Forward sequential
2. Reverse sequential
3. Random
Subtest 03 Random address/data
This subtest writes random data in a random length to random addresses. This data
is then read and compared to the original data.
3-28
: XX
: XXXXX ERROR COUNT
: XX READ DATA
: XXXXXX STATUS
3.13 Hard Disk Test
XXX DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] :
[Ctrl]+[C]
: XXXXX
: XX
: XXX
PORTEGE A200 Maintenance Manual (960-499)
test end
: key stop