Dismantling - Husqvarna 435 Workshop Manual

Dismantling the carburettor
1. Dismantle the cylinder cover and the air filter.
2. Disassemble the handle holder (see figure 29).
3. Push the throttle actuator rod out of the han- Push the throttle actuator rod out of the han-
dle part. Unhook it from the carburettor (see
figure 30).
4. Remove the return hose (B) and suction hose
(C). Loosen the fuel pump (D). Let the fuel
hose (G) remain in place (see figure 31).
NOTE!
Take care when lifting out the carburettor so
that the fuel hose does not become loose.
5. Loosen the screws (E) and unhook the rubber
mountings (F) (see figure 32).
Fig 29
Fig 30
Fig 31
Fig 32
Repair instructions
35
English –