Side Burner Lid - Kenmore 122.166419 Use And Care Manual

Liquid propane gas grill
Hide thumbs

Advertisement

Checking for LP gas leaks
Never test for leaks with a flame. Prior to first use, at
the beginning of each season, or every time your LP
gas tank is changed, you must check for gas leaks.
,
2.
,
Make a 50/50 (soap/water) mild soap solution.
Turn the control knobs to full OFF position; then
turn gas ON at supply tank.
Apply the soap solution with a clean brush to all
gas connections. See below. If growing bubbles
appear in the solution the connections are not
properly sealed. Check each fitting and tighten or
repair as necessary.
Gas Connection Leak Check
4. If you have a gas connection leak you cannot
repair, turn gas OFF at supply tank, disconnect
fuel line from your grill and call 1-800-4-MY-HOME
or your gas supplier for repair assistance.
5. Also apply soapy solution to the tank seams. See
below. If growing bubbles appear, shut tank OFF
and do not use or move it! Contact an LP gas
supplier or your fire department for assistance.
Gas Tank Leak Check
Grill Lighting Instructions for Main Burners
1. Do not smoke while lighting grill or checking gas
supply connections.
2. Be sure that LP gas tank is sufficiently full.
,/_
WARNING
Failure to open grill lid during the lighting
procedure could result in a fire or explosion
that could cause serious bodily injury, death,
or property damage.
,
4.
5.
Be sure all gas connections are securely
tightened.
Open the grill main lid and side burner lid.
Push and turn any main burner knob to_i_HI
position, holding knob and Electronic i9_nition
button for 3 to 5 seconds to light burner.
,
,
,
To light additional burners, turn burner
to_
HI. Push and hold electronic
knob(s)
ignition button to light burner. Adjust knob(s)
to desired setting.
If the burner does not light after 5 seconds,
turn knob to OFF. Turn gas OFF at LP tank
and wait 5 minutes for gas to clear. Then
turn gas ON at tank and repeat step 5
If burner still does not light, see Match
Lighting section and If Grill Still Fails to Light
section on following page.
USING THE SIDE BURNER:
Inspect the gas supply hose prior to turning the gas
"ON". If there is evidence of cuts, wear or abrasion,
it must be replaced prior to use. Do not use the
side burner if the odor of gas is present.
WARNING: Always keep your face and body as
far away from the burner as possible
when
lighting.
LIGHTING INSTRUCTIONS
FOR SIDE BURNER
1. Open side burner lid fully.
2. Push and turn side burner knob to "_HI
position.
Push and hold Electronic Ignition button for 3-5
seconds to light burner. If the side burner does
not light after 5 seconds, turn knob to OFF. Turn
gas OFF at LP tank and wait 5 minutes for gas
to clear. Then turn gas ON at tank and repeat
step 2.
3. If burner still does not light, see Match Lighting
section and If Grill Still Fails to Light Section on
following page.
13

Hide quick links:

Advertisement

loading

  Related Manuals for Kenmore 122.166419