Configuring System Display Settings - Honeywell HRGX45 User Manual

Configuring System Display Settings

This section describes how to configure general display settings, set the camera order,
enable/disable live view for one or more cameras, and set up channel-zero encoding.
Configuring General Display Settings
You can configure general display settings in the System Settings menu. Follow the instructions
below to set up video and audio outputs, the live view screen layout, and the auto-switching
dwell time.
To configure general display settings:
1.
2.
3.
Go to Menu > Settings > Display.
On the Display page, under General, configure the following settings:
• Video Output Interface
• Live View Mode
• Dwell Time
• Enable Audio Output
• Event Output
• Full Screen Monitoring
Dwell Time
Click Apply to save your settings.
Sets the main video output for live view and playback mode.
Select VGA/HDMI (default) or Main BNC.
Sets the screen layout for live view mode.
Available options are dependent on DVR type.
Sets the channel switching interval time in seconds when
auto-switching is enabled in live view mode. Select a value
between 5 s and 300 s or select No Switch.
Select/clear the check box to enable/disable audio
output for the selected main video output.
Sets the video output for event recording.
Select VGA/HDMI (default) or Main BNC.
Sets the time in seconds to show alarm events on screen.
Viewing Live Video | 39
800-16694 - A - 04/2014