Programming Local Wireless Keys; Wireless Keys Programming; Wireless Key Function Chart; Default Loop Functions - Honeywell ADEMCO 6152RF Installation And Setup Manual

PROGRAMMING LOCAL WIRELESS KEYS

This section is for first time enrolling and setup of wireless keys. To edit or delete a wireless key that is already enrolled; refer to the,
Deleting, Replacing or Editing Wireless Keys section.
Table 7 – Wireless Keys Programming
Step
Enter
Within 30 seconds of power up, press and hold down the
Program
and
Mode
Enter [8] Wireless Key Auto Enroll. The 6152RF automatically advances
to first available device number.
Note: If all 8 devices have been enrolled, the 6152RF beeps three times
and continues to alternately flash "oo" and "- -."
Press any button on the wireless key to enroll the serial number.
The keypad will beep three times.
Note: If enrolling a wireless key in high security mode, see the Installation
Instructions for that Model for further information.
Press
times.
OR
Press
and returns to the "enroll serial number" prompt.
Note: A maximum of 8 wireless keys may be enrolled into the 6152RF.
These wireless keys DO NOT occupy any zones supported by the
control.
Enter [2] Wireless Key User Code. Enter the 4-digit user code for the
wireless key.
Note: The user code must be a valid code that is programmed in the
control panel. If the code is deleted or changed in the control, the
wireless key will no longer work.
Press
If finished programming, press
programming as noted below.
Enter [4] Wireless Key Loop Functions. Enter the loop number (1-4).
The 6152RF is shipped with the loop functions pre-programmed
(see illustrations in the next column):
Loop 1
Loop 2
Loop 3
Loop 4
To change any of the loop functions enter one of the choices
listed in the Wireless Key Function Chart below.*
* Entering a number other than the one specified may give unpredictable
results.

Wireless Key Function Chart

Function
Disarming
Arming Away
Arming Stay
Arming Maximum (Away Instant)
Arming Instant
Panic Alarm
Produces type of alarm [* & #]
programmed in control panel.
Action
keys at the same time for 3 seconds.
to accept the serial number; the 6152RF beeps two
to reject the serial number; the 6152RF beeps once
to accept the user code.
to exit. Otherwise, continue
Close the 6152RF On-Board Relay for 2 sec.
1 (Disarm)
2 (Arm Away)
3 (Arm Stay)
Entry
1
2
3
4
7
# + 99
"oo, - -" flash alternately
See Table 5 for more details.
Flashes "d" with the next available device
number; followed by "- -" (four times) and then
repeats the sequence.
Alternately flashes "d" with the device number
and the serial number.
If you accept the serial number, the display
flashes the device number and a hyphen.
If you reject the serial number, the display
flashes "d" with the device number followed by
"- -" four times.
Flashes "u4." Once the 4-digit user code is
entered, the display flashes "u4," the first two
digits, and then the last two digits of the user
code.
Flashes "Ln."
Once the loop number is entered, alternately
flashes "L" with the loop number; and the
present function.
LOOP 3
Arm AWAY
LOOP 4
Arm STAY
- 4 -
Display

Default Loop Functions

LOOP 2
Disarm
LOOP 1
Close on-board relay
for 2 seconds
5834-4 / 5834-4EN