Advertisement
4.1
PREPARATION
4.1.1 Precaution
Camera system and deck system of this model are specially
adjusted by using PC.
However, if parts such as the following are replaced, an
adjustment is required. The adjustment must be performed in a
Service Center equipped with the concerned facilities.
• EEP ROM (IC1005 of MAIN board)
• OP BLOCK ASSEMBLY
• MONITOR ASSEMBLY
In the event of malfunction with electrical circuits, first find a
defective portion with the aid of proper test instruments as shown
in the following electrical adjustment procedure, and then
commence necessary repair/ replacement/adjustment.
• In observing chip TP, use IC clips, etc. to avoid any stress.
Prior to replacement of chip parts (especially IC), remove the
solder completely to prevent peeling of the pattern.
• Use a patch cord if necessary. As for a patch cord, see the
BOARD INTERCONNECTIONS.
• Since connectors are fragile, carefully handle them in
disconnecting and connecting the FPC.
4.1.2 Required test equipment
• Personal computer (for Windows)
• Color TV monitor
• Oscilloscope (dual-trace type, observable 100MHz or higher
frequency). The one observable 300 MHz or higher frequency
is recommended.
• Digital voltmeter
• DC power supply or AC adapter
• Frequency counter (with threshold level adjuster)
1-18 (No.YF244<Rev.001>)
SECTION 4
ADJUSTMENT
4.1.3 Tools required for adjustment
Torque Driver
YTU94088
Chip IC Replacement Jig
PTS40844-2
INF Adjustment Lens Holder
YTU94087
Gray Scale Chart
YTU94133A
Service Support System
YTU94057-111
PC Cable
QAM0099-002
IDE Adapter
YTU96041
Bit
Tweezers
YTU94088-003
P-895
Cleaning Cloth
INF Adjustment Lens
KSMM-01
YTU92001B
Mini Stand
Light Box Assembly
YTU93108
YTU93096B
Color Bar Chart
Focus Chart
YTU94133C
YTU92001-018
Communication Cable
YTU93111-1
Charing Battery Adjuatment Jig
Jig Connector Cable
YTU93112A
YTU93106D
IDE Adapter
FPC Wire
YTU96043
YTU94165-40
Advertisement
