Advertisement
3.2.4 Disassembly of [23] MONITOR ASSY
CAUTIONS
(1) During the procedure, be careful in handling the LCD
MODULE and other parts. Pay special attention not to
damage or soil the monitor screen.
If fingerprints are left on the screen, wipe them with clean
chamois leather or a cleaning cloth.
Removing MONITOR ASSY
(1) Remove the 2 screws (1 and 2).
(2) Turn the HINGE UNIT ASSEMBLY 90°, and remove the
2 screws (3 and 4).
(3) Remove the MONI.COVER ASSY by removing the 4
hooks (L23a-d).
NOTE23a:
During the procedure, be careful in handling the KNOB
(CURSOR) attached to the BOARD ASSY as it sticks
out toward the LCD screen.
(4) Release the lock of the connector (CN23a), and remove
the HINGE UNIT by lifting it up.
NOTE23b:
During the procedure, be careful in handling the FPC.
(5) Release the lock of the connector (CN23b), and pull out
the FPC.
(6) Release the lock of the connector (CN23c), and pull out
the FPC.
(7) Remove the 4 screws (5-8), and remove the BKT(LCD/
U) .
(8) Remove the MONITOR BOARD ASSY .
NOTE23c:
When attaching the MONITOR BOARD ASSY, be
careful to avoid any misalignment or unevenness of
the parts underneath.
Attach the MONITOR BOARD ASSY by lifting up the
MONITOR CASE as the KNOB (CURSOR) that is at-
tached to the BOARD sticks out toward the LCD
screen.
(9) Remove the SPACER (PET).
(10) Remove the BACK LIGHT,LCD MODULE, SPAC-
ER(LCD) and BKT(LCD).
NOTE23d:
Disassemble the four parts (BACK LIGHT, LCD,
SPACER (LCD), and BRACKET (LCD), that will be
disassembled later, if necessary as they can be han-
dled as a whole unit.
1-16 (No.YF244<Rev.001>)
Advertisement
