Cycle Status Indicators; Drying System; Overfill Protection Float - Kenmore 665.1776 Use And Care Manual

Portable dishwasher

Hide thumbs Also See for 665.1776:

Use & care manual (60 pages)

Table of Contents

Available languages

Enlarged version

Hi Temp

Select this option to heat the water to 140ºF (60ºC) during parts

of the cycle. Heating the water helps improve washing results.

This option adds heat, water and wash time to parts of the cycle.

Hi Temp wash is useful when loads contain tough food soil items.

NOTES:

Pots Pans automatically uses this option. Hi Temp wash is an

option with the Heavy Wash and Normal Wash cycles.

Use this option for heavier than normal-soiled loads.

Heated Dry

The Heated Dry option in combination with rinse aid will give you

excellent drying results. The energy to use Heated Dry costs

pennies per cycle. Heated Dry is on when the light is lit on the

Heated Dry button. Be sure to load plastic items in the upper rack

to avoid damage.

You may turn off the Heated Dry option by pressing HEATED DRY

so that the light goes off. However, you will have items in your

dish load that will not be dry at the end of the cycle.

NOTE: The Heated Dry option is used in all cycles except Quick

Rinse.

Lock On

Use the Lock On to prevent unintended use of the dishwasher.

You can also use the lock feature to prevent unintended cycle or

option changes during a cycle.

When LOCK ON is lit, all buttons are disabled.

NOTE: The dishwasher door can be opened while the controls

are locked. However, the lock must be turned off and the Start/

Resume button pressed to resume the cycle.

To turn on the Lock

Press and hold HEATED DRY for 4 seconds. LOCK ON glows.

If you press any pad while your dishwasher is locked, the light

flashes 3 times.

NOTE: If the Heated Dry option is selected, the light will

temporarily turn off until Lock On glows.

To turn off the Lock

Press and hold HEATED DRY for 4 seconds. The light turns off.

Delay Hours

Select this option to run your dishwasher at a later time or during

off-peak hours. You can add items to the load anytime during the

delay. After adding items, firmly close the door until it latches and

press START/RESUME, or the delay will not continue.

To delay the start

1. Press the delay button to choose the number of hours

delayed.

2. Select a wash cycle and options.

3. Press START/RESUME.

The dishwasher starts the cycle in the selected number of hours.

NOTES:

To cancel the delay and cycle, press CANCEL/DRAIN.

To cancel the delay and start the cycle, press START/

RESUME.